JM 1ST APPROACH

This high-powered device will drive up to two of any of these subwoofer modules and delivers 300 watts into an 8-ohm load (one subwoofer module) and 500 watts into a 4-ohm load (two subwoofer modules). It also comes with rack ears for fast and secure placement into any standard 19-inch rack.

To keep end users from inadvertently tampering with performance levels, the majority of the RSA-500s controls are housed on its rear panel. The fuse is also included on the back for quick and easy replacement. A detachable IEC power cord allows for the simple removal and reinstallation of the entire amplifier unit. The RSA-500 was also designed to play nice by offering standard input/output connectivity that will support any type of system.

[Features]

EQ switch for use with different subwoofers

Selectable signal-sensing or voltage triggered auto-on/off circuit

300 watts continuous into 8 ohms or 500 watts continuous into 4 ohms

Line and speaker level inputs

Rack ears included

[RSA-500 Specifications]

frequency response 20Hz-1kHz 3dB

amplifier power FTC Rated Power: 300W into 8 ohms, 500W into 4 ohms, 20Hz-1kHz @ GT 1.5% THD Dynamic Power: 875W into 8 ohms,

low pass crossover Continuously variable from 40-120Hz,

amplifier BASH Hybrid

phase Switchable between 0 and 180 degrees

enclosure type Use only with RW-5802, and AW-800-SW subwoofer enclosures (either one or two)

inputs 2 Gold-plated speaker binding posts, 2 Gold-plated RCA phono jacks plus single LFE

outputs 2 Gold-plated unfiltered RCA phono jacks plus single LFE

auto power on 2 second ON delay, 15 minute OFF delay

dimensions 3.5" (8.9cm) H x 17" (43.2cm) W x 12.6" (32cm) D (without rack ears)

weight 18 lbs. (8.2kg)

features Selectable EQ, Speaker Level In, Low voltage trigger, rack ears included

finishes Black anodized aluminum face plate

voltage 110/120 VAC 60Hz